Sơn phủ epoxy Carbothane 134HS

Danh mục:

Mô tả

Carbothane® 134 HS
PRODUCT DATA SHEET
February 2021 0848 Page 1 of 4
S E L E C T I O N & S P E C I F I C AT I O N D ATA
Generic Type Acrylic aliphatic polyurethane
Description
An attractive, high gloss, high solids topcoat which is easily applied by airless or conventional spray
to yield a smooth, easily cleanable surface. Recommended use as a finish coat for the exteriors
of tanks, equipment, piping, structural steel, and concrete surfaces where chemical resistance,
toughness, and weatherability are required. An excellent coating for use in chemical processing,
pulp and paper, petro-chemical, bridge, offshore, railcars, heavy marine, institutional and waste
treatment facilities where a highly resistant and attractive coating is desired. Not recommended for
immersion service.
Features
• Excellent weatherability
• Excellent flexibility
• Excellent abrasion resistance
• Available in Carboline’s Rapid Tint System
• Meets most VOC requirements
• Indefinite recoatability
Color Refer to Carboline Color Guide. Certain colors, particularly in non-leaded safety oranges, reds and
yellows may require multiple coats for adequate hiding. Check color suitability before use.
Finish High Gloss
Primer Refer to Substrates & Surface Preparation.
Dry Film Thickness
2 mils (51 microns) per coat
Additional thickness may be required over rough surfaces for appearance. Dry film thickness in
excess of 4 mils per coat is not recommended
Solids Content By Volume 66% +/- 2%
Theoretical Coverage
Rate
1059 ft²/gal at 1.0 mils (26.0 m²/l at 25 microns)
529 ft²/gal at 2.0 mils (13.0 m²/l at 50 microns)
Allow for loss in mixing and application.
VOC Values
As Supplied
: 2.4 lbs./gal (288 g/l)
Thinner 214 : 13 oz/gal 2.8 lbs./gal (336 g/l)
Thinner 215 : 10 oz/gal 2.8 lbs./gal (336 g/l)
Thinner 25 : 12 oz/gal 2.8 lbs./gal (336 g/l)
These are nominal values and may vary slightly with color
Dry Temp. Resistance
Continuous: 300°F (149°C)
Some discoloration and loss of gloss may be experienced at elevated temperatures.
Topcoats Carbothane Clear Coat when required
S U B S T R AT E S & S U R FA C E P R E PA R AT I O N
General
Surfaces must be clean and dry. Employ adequate methods to remove dirt, dust, oil and all other
contaminants that could interfere with adhesion of the coating. For all surfaces prime with specific
Carboline primers as recommended by your Carboline sales representative. Refer to the specific
primer’s Product Data Sheet for detailed requirements of the specified primer.

Đánh giá

Chưa có đánh giá nào.

Hãy là người đầu tiên nhận xét “Sơn phủ epoxy Carbothane 134HS”

Email của bạn sẽ không được hiển thị công khai. Các trường bắt buộc được đánh dấu *